Sounds too good to be true? Every hot water cylinder contains a sacrificial anode which prevents the breaking down of the tank and components. As the name suggests “sacrificial” would mean that at some point it would have to be replaced to maintain this form of protection. In the image to the right you can clearly see the difference within 10 years of operation. Most house holders are not made aware of this fact and unknowingly allow the continuation and breakdown of their relatively young or new hot water cylinder. By replacing this sacrificial rode you can easily add another 10 years to its operation saving significant cash by preventing the breakdown of metals.
The sacrificial anode (also called an anti-corrosion rod) is typically made of magnesium. It it used to attract corrosive elements so that the tank itself will not corrode as quickly. It can be replaced when it is badly corroded.
But when your hot water cylinder is installed in a tight spot with limited height which is the case in most scenarios, how can you replace this rode (typically over 1 meter length) without actually removing / disconnecting (which would cost you more than its worth) the hot water cylinder to fit it in?
Making it easy to change a cylinder anode when clearance is tight.
When is time to replace your sacrificial anodes you might be faced with several challenges. Either you will have to drain and remove the hot water cylinders or you may have to put a hole through the ceiling above for access. So what is the solution? A flexible Anode! this specialized anode requires less than 250mm clearance and can be installed within 1 hour. So whether you have an existing cylinder or getting a new one, why not ask to be upgraded to one of these allowing you to make the replacement when its due? Saving you cash long term!
Please ask our team about this upgrade which can be purchased for under $200 with a new installation.
You can purchase our flexible sacrificial anode here: Flexible Hot Water Cylinder Anode